RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Electric Training (https://www.rcuniverse.com/forum/electric-training-102/)
-   -   Tx battery indicator light problem (https://www.rcuniverse.com/forum/electric-training-102/4618099-tx-battery-indicator-light-problem.html)

trevormatney 08-13-2006 04:36 PM

Tx battery indicator light problem
 
Hi to you! I have a Futaba 4YF transmitter that I bought approx. 2 years ago, but have not used. I charged the battery for about 24 hrs, which should be plenty to fully charge it. there are two lights on the tx, a red one and a green one. The problem is that both stay lit when the tx is on. Any idea why this is? I want to use the radio to fly a plane I just finished assembling, but I'm afraid the Tx battery will die, closely followed by my new plane! Any advice would be appreciated. Thank You in advance!

AJ1202 08-17-2006 02:49 PM

RE: Tx battery indicator light problem
 
You might want to consider trying a different batt to be sure that is the problem, 2 yr for a batt to sitt not being used is a long time
the batt may not be any good,, just a thought. do you have anyway to discharge the battery and recharge it, can you test it to see if it is indeed charged to proper level

trevormatney 08-18-2006 11:31 AM

RE: Tx battery indicator light problem
 
Well I suppose I could make charge leads for my accu-cycle charger, and discharge then charge the battery. Would that tell me how well the battery is charging?

AJ1202 08-18-2006 03:34 PM

RE: Tx battery indicator light problem
 
Trevor, the best way to determine if a batt is charged is to test it after it's charged and see what's in it. You can discharge it by using a small light, like a light bulb for the blinker of your car, just stick wire into the batt plug and tape them to the terminals of the light and let it go dead before you recharge it. or you could just turn your TX on and leave it on and see how long it takes it to die out, just use the controls while sitting there watching TV so it trys to send a signal, or go into the programming mode, that seems to use batt power pretty quick. Also it is important to cycle your batt about 3 times before you use it anyway. this helps it build memory for charging

ryan_t888 08-26-2006 08:47 PM

RE: Tx battery indicator light problem
 


ORIGINAL: trevormatney

Hi to you! I have a Futaba 4YF transmitter that I bought approx. 2 years ago, but have not used. I charged the battery for about 24 hrs, which should be plenty to fully charge it. there are two lights on the tx, a red one and a green one. The problem is that both stay lit when the tx is on. Any idea why this is? I want to use the radio to fly a plane I just finished assembling, but I'm afraid the Tx battery will die, closely followed by my new plane! Any advice would be appreciated. Thank You in advance!
Yes, this indicates the battery is sufficient for flying. When the green light goes out bring the plane in. If the red light starts blinking it's bad news.:) - low voltage

Ryan


All times are GMT -8. The time now is 02:32 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.