sw74gls

Hi Guys not been on here in a long time been away doing other hobbies etc However I have I could use a little advise please, I have a Paw 55 and just recently required a muffler with two fibre gaskets, my only concern is how do i get the cylinder to unscrew so i can slide the muffler over etc as there is no socket anywhere on the cylinder it is completely smooth all the way round ???? Really appreciate your help, Many Thanks Si...

qazimoto

My Feedback: (1)

You need a "Strap Wrench". These can be bought at auto supply outlets or you can just make one as shown. The one in the pic is in tightening mode. Turning it over will allow it to loosen the cylinder.

sw74gls

Thank you very much for the reply I will get onto making a tool similar to yours in the picture tomorrow, once again thank you!!!!!