dip switch settings
 

can any 1 tell me what the dip switch's are supposed to be set at?my son set them all to off :(

RE: dip switch settings
 

Dip switch setting should be 1. off 2. on 3. off 4.on 5. on 6. off 7. on 8. on 9. on 10. off
Hope this helps

RE: dip switch settings
 

what about 11 and 12 ?


thanks alot

RE: dip switch settings
 

which helicopter?

Andy

RE: dip switch settings
 

setting are
1. off
2.on
3.off
4.on
5.off
6.on
7.off
8.off
9.on
10.off/ if on need 11, 12 off
11.off/ if on need 10, 12 off
12.off/ if on need 10, 11 off

RE: dip switch settings
 

exceed g2's 11 and 12 should be OFF

ANdy

RE: dip switch settings
 

i have set all the dip switch's to the right spot and it still wont lift off.i unpluged the motor and checked the pitch slider to see if my pitch was off and the slider was right in the middle.what other setps should i take now to narrow down the problem and fix it.it was flying perfect befor my son turned the switch's off.do i have to reprogram the radio and is there a cirtain way to do it?


also it is the raptor g2 v2 dont know if they used a diff radio with the v1 g2

RE: dip switch settings
 

if you can not get it lift off your pitch is off. put dip switch 10 to ON and adjust the pitch.

Your pitch slider needs to move up so you get a positive pitch

Andy

RE: dip switch settings
 

i have used the manual to setup the pitch and it still wont lift off.it almost like something reversed cause at full throttle it has negitive lift and when you let off the throttle quite quick it will start to lift off...???.is there anyway that the motor qot reversed.mine spins up clock ways.also the blades are supposed to be thin side going with clock ways or thick part?cause my blades the thick part is going with the clock ways spin.

thanks for the time yadac123

RE: dip switch settings
 

i have got it figured out thanks alot for the help guys..it was #6 is supposed to be off.now to figure out what ball link to adjust to stop it from going right.i ahve the trim all the way left and it still goes right.is it the long 1 or the short ball link?

RE: dip switch settings
 

also i wanna buy the cnc upgrade's for it and i have found a site that has the full rotor head and tail assemably for the walkera 36.i have heard i can use these parts is it true?just wanna make sure befor i order anything :)...