Upgrading Servo to digital
 

<span style="font-size: small">I have the exceed rc g2 and would like to upgrade to a digital servo for the tail rotor. Looking for for any input on gyro/servo combinations that would work with this heli.</span>

RE: Upgrading Servo to digital
 

the stock gyro can support digital servo so you can get this http://www.xheli.com/ra12grmipldi1.html

Andy

RE: Upgrading Servo to digital
 

whats the set up procedure for changing the gyro over to digital?

Tim

RE: Upgrading Servo to digital
 

it's the same. Connect the arm to the servo 90 degree to the case and then connect directly to the receiver to center that. The connect it back to the gyro. you need to set the left switch to DS to let the gyro know that you have a digital servo now.

Andy

RE: Upgrading Servo to digital
 

Ijust updated my tail servo to an EXI Digital servo http://www.xheli.com/exi-servo-d213f.html. Andy described the process. Just a noob point...I mounted mine 180 degrees from they way it came from the factory. So Ireversed the direction on the gyro and transmitter if Iremember correctly.Then afterwards Ifigured out what Idid.:-) Take note on how the factory one is mounted and you'll be fine. Don't forget to flip the switch on the gyro to DS now that it's a digital servo.

For what it's worth, I noticed a "touch" of tail wag with the new digital servo.Iguess it's just a bit quicker to respond than the original so it acts just slightly different.I turned down the sensitivity a bit on the gyro to compensate.Didn't have to adjust it, but I didn't like the slight wag/twitch the tail exhibited.

sconner