What to do with k&b,kbv ducted fan motors?
#1
Senior Member
Thread Starter
Join Date: Mar 2007
Location: Rockford, MI
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
What to do with k&b,kbv ducted fan motors?
I have 6 82, size ducted fan engine Most are k&b and 1 Mint kbv with( updated and tested note by bob v). Can I possibly mount a header,pipe and prop on them? Was thinkink like a hot rod big stick or somthing. any ideas thanks
#2
Senior Member
Thread Starter
Join Date: Mar 2007
Location: Rockford, MI
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
RE: What to do with k&b,kbv ducted fan motors?
11cc .one say KB with ser #,another says kbv another KB and two that look just like the kbv but have no makers marks.all have rear carbs, exhaust.thanks. could not edit
#3
Senior Member
My Feedback: (3)
RE: What to do with k&b,kbv ducted fan motors?
If you go with that idea, make sure the airfoil is optimized for speed. Even if you have to utilize some basic modeling skillz [OMG, he means actual work..!!] to make that happen.
Eliminate any other major "drag brakes" like large expanses of firewall hanging out behind the engine and make a cowl that blends into a bullet shaped spinner.
All the little drag reducing details add up to a greater result until the basic design "hits a wall", then it's time to go back to the drawing board in search of a better design to make best use of your powerplant.
Eliminate any other major "drag brakes" like large expanses of firewall hanging out behind the engine and make a cowl that blends into a bullet shaped spinner.
All the little drag reducing details add up to a greater result until the basic design "hits a wall", then it's time to go back to the drawing board in search of a better design to make best use of your powerplant.
#6
Senior Member
Thread Starter
Join Date: Mar 2007
Location: Rockford, MI
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
RE: What to do with k&b,kbv ducted fan motors?
Still no ideas on how to mount a prop? The end of the crank is like a 1/8 .21 (car engine) I once put an electric prop adaptor on a .21 car engine. to break engine in. Prob gonna sell them. Thanks for the offers. Gonna save 1 or 2 for possible ducted fan project in future. Saw a few pretty rad 1,s
http://youtu.be/NesqytUlRoI
http://youtu.be/5YSlq3RYXJY
cheers
http://youtu.be/NesqytUlRoI
http://youtu.be/5YSlq3RYXJY
cheers