Which servos are you using on this plane? I am thinking about Hitec 5625 on everything except the rudder; I do plan to go with an 8611 on the rudder. Tom, you recommended a servo for the ailerons to me over the phone today, but I couldn't remember which one. What do you thing about the 5625's. I would like to stay with digital. (except for the throttle)

Thanks

Hitec 5945's all round on mine except for the rudder, which is the JR 8511 in the UK, known as the 8611 in the US... I heard the numbers were changed for the UK version , so as they can tell if we bought it from oversea's.... therefore no warranty.[]

What I told you was Hitec 6635. These are Karbonite gear servos with 80 oz. of torque. They are pretty good for smaller planes like the 73" Edge and the Ultimate's ailerons.

I don't like the Karbonite gear output shaft on heavily loaded surfaces, it's too flexible, but on a small surface like the Ultimate's aileron it works fine.

BTW I have a whole bunch of these 6635 servos used, see the "Special Deals" on www.wildharerc.com, none have more than a few flights.

TF

My ultimate flies with 5625's on all surfaces except Rudder which is a big 5375 (if memory serves me). No problems at all!

I have 5945's all around and a 8611 on rudder. The 5945s are overkill, however I do plan on putting them in another plane down the road. So I try to buy once so I don't need to buy stronger later.