Picco .12 HELP
07-21-2006 | 01:00 PM
#1
Thread Starter
Junior Member
Joined: Dec 2005
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
From: Portland, OR
Picco .12 HELP
I got RS4 3 with Picco .12 engine.
I searched Picco site and can't find anything on the factory carb needle settings.
If you please help me out. I need to set card back to factory needle settings.
Thanks
I searched Picco site and can't find anything on the factory carb needle settings.
If you please help me out. I need to set card back to factory needle settings.
Thanks
07-23-2006 | 09:18 PM
#2
Junior Member
Joined: Jul 2005
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
From: Columbus, OH
RE: Picco .12 HELP
I have a XP-12 Picco (TP095) this what the instructions say.
Initial Settings: High speed neddle 1.5 turns out, it then states it may need to be more for break-in. Low speed 3> 3.5 out (it does not mention break-in).
Hope this helps
Initial Settings: High speed neddle 1.5 turns out, it then states it may need to be more for break-in. Low speed 3> 3.5 out (it does not mention break-in).
Hope this helps
09-05-2006 | 12:06 PM
#3
Senior Member
Joined: Aug 2006
Posts: 361
Likes: 0
Received 0 Likes
on
0 Posts
From: San Francisco,
CA
RE: Picco .12 HELP
look at page 3. it has all the factory and suggested settings.
http://www.ofna.com/pdf/eng-picco12r...%20warranty%22
http://www.ofna.com/pdf/eng-picco12r...%20warranty%22
