Programing Expo on Radio
#1
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
From: Selkirk,
MB, CANADA
Switched to 2.4 gHz spektrum...lots of bells and whistles...going to do the high rate/low rate thing. I understand expo gives you lots of control or takes away a little if things are too twitchy. Just wondering if I should be adding positive or negative expo. I would like the sticks to be comfortable, not too touchy...
#2
Positive expo on a DX7 softens the control near the center and speeds it up near the end of the travel. Start off with more than you think you need as it's easier to fly if the controls are too soft then speed things up until you get it flying like you want.
#3
Thread Starter
Senior Member
Joined: Apr 2006
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
From: Selkirk,
MB, CANADA
thanks for the input...will start with a bit and turn this up as I get comfortable. I did play around a bit a set some high and low rate settings...




