T14SG Range Check Mode
08-19-2017, 08:10 AM
#1
Thread Starter
T14SG Range Check Mode
Manual states "touch and hold the RTN button while turning on the transmitter."
Range check does NOT come up. Any other way to do this?
I just got thru converting all of my 72MHZ stuff to this transmitter and would hate to have to stop flying while the xmitter goes to and back from the Service Center.
Range check does NOT come up. Any other way to do this?
I just got thru converting all of my 72MHZ stuff to this transmitter and would hate to have to stop flying while the xmitter goes to and back from the Service Center.
08-20-2017, 11:31 AM
#2
Thread Starter
Problem Solved
Rather than touch just the center "RTN" button, one must cover the entire circular button including the "LNK", "SYS", etc portions.
What a PITA user guide. Copying model(s) from xmitter memory to the SD card was a learning process in itself.
I need an T14SG video for dummies like me. Anybody know of one?
What a PITA user guide. Copying model(s) from xmitter memory to the SD card was a learning process in itself.
I need an T14SG video for dummies like me. Anybody know of one?
