synthesized transmitter module tool to change channels
#1
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Mar 2002
Location: Beaumont,
TX
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
synthesized transmitter module tool to change channels
I just purchased a used 9cap with a synthesized transmitter module. My question is do I need a special screw driver to change the channel? In ppictures I see the plactic one used.
H e l p ......
H e l p ......
#3
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: synthesized transmitter module tool to change channels
Hi richb1492,
If you purchased this transmitter new, the plastic screw driver should have been included.
If you would like, we'll be happy to send you one, just contact us at [email protected] and we'll get your address to mail one out to you.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
If you purchased this transmitter new, the plastic screw driver should have been included.
If you would like, we'll be happy to send you one, just contact us at [email protected] and we'll get your address to mail one out to you.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]