8FG dual elevator programming
 

I am setting up a 30cc plane the uses a servo for each elevator. I will be utilizing a R617FS receiver and connecting the servos to channels 2 and 7. Can you explain the required transmitter programming to accomplish this?

Thanks

RE: 8FG dual elevator programming
 

If you are using a 7 channel receiver, you can go into the Function menu and assign channel 7 as elevator. It will automatically set this to J2 if you are in Mode 2.


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]

RE: 8FG dual elevator programming
 

Thanks Krysta, it works...