Futaba RX's & HV servos
Hello I am after some information on Futaba receivers & HV servos first of I can't see ay specifications for range on the followinfg receivers
Fasst R7008SB, 6208SB Fhss R2008SB. R2006GF.R2006GS Please can you advise which of these are full range. My second query is regarding Hv servos & RX's in the specs for these units the voltage is quoted as 7.4v but a fully charged 2 cell LI-PO battery is 8.4v will they be ok with this or will this damage them?? Thanks Dave |
RE: Futaba RX's & HV servos
All of the receivers listed are full range.
The High Voltage receivers will be able to handle your 2 cell lipo with no problem. Sincerely, Krysta Product Development & Support Specialist Futaba Service Center USA [email protected] |
RE: Futaba RX's & HV servos
Hi Krysta, I am not quite clear on this point. If the R6208 is supplied by a 8.4v 2s lipo I understand the RX has no issues and is rated for this, but what will be the voltage supplied to the servos connected to any of the 6208 servo ports? And is the what is the voltage supplied to the sbus port and connected sbus devices?
I think I know the answer, but would like to verify. Thanks, |
RE: Futaba RX's & HV servos
Bax, Krysta, if you can confirm the R6208SB appears to have a single power domain? Meaning the supplied voltage is what is "delivered" to all servos without level shifters or any type of voltage regulation. That seems to be what I measure.
|
RE: Futaba RX's & HV servos
The battery voltage delivered to the receiver is passed straight through to the servos. There is only a battery bus for the power leads.
|
All times are GMT -8. The time now is 04:01 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.