SWITCH ASSIGNMENT
 

I HAVE A FUTABA 9C. I AM TRYING TO ASSIGN SWITCH C TO CHANNEL 5 TO TURN OFF AND ON A STABILIZER. I HAVE ASSIGNED SWITCH "C" TO CHANNEL 5. IT INDICATES ON THE TX THAT IS WORKING BUT WILL NOT ACTIVATE THE STABILIZER PLUGGED INTO CHANNEL 5 ON MY RECEIVER. THE STABILIZER WORKS WITHOUT THE SWITCH. NEED HELP.

RE: SWITCH ASSIGNMENT
 

When you say "stabilizer", what are you asking about? What device are you trying to use? If it's a piece of non-Futaba equipment, you may need to ask the maker about getting it set up.

RE: SWITCH ASSIGNMENT
 

THE DEVICE I'M TRYING TO UTILIZE IS AN EAGLE TREE SYSTEMS2/D3/D GUARDIAN STABILIZER. THIS HAS BEEN SET UP PROPERLY. I HAVE ALSO TRIED A SPARE SERVO IN CHANNEL 5 AND THE SWITCH DOES NOT OPERATE IT. I COULD POSSIBLY BE DOING SOMETHING WRONG IN THE PROGRAMMING OF THE TX, BUT HAVE TRIED EVERYTHING IN THE MANUAL TO NO AVAIL. THX FOR THE REPLY.

We don't k now anything about the Eagletree product. You will have to call them for help in using it.