Throttle cut 14SG
 

hey guys whenever I try to program throttle cut on my 14 SG, I've got it assigned to switch SE, it moves the servo when activated. My problem is when activated it goes in reverse , not the correct direction. So when activated , it increases the throttle rather than decrease the throttle. Is there a way to reverse this???? It happens on all planes that I have assigned. Help. Thanks

Richard

Richard
If you want to reverse the switch, go to SYS, H/W SET, H/W REVERSE. Select SE and change from NORM to REV.
Back on the LINKAGE, THR CUT menu, note that when activated, the throttle (shown by dark arrow on left) jumps to the cut position ('<' on right), so you have to have the '<' set lower than the dark arrow using the POS %.
Hope this helps.
-Ron

Thanks Ron I'll give that a try soon as the rain quits here in Alabama.

Richard

Ron thats worked , thanks for your help

Richard