Use of Dual Receivers using 14SG
I have a 14SG radio and a couple of planes that I want more functions than an 8-channel receiver will handle. I don't want to buy a 14 channel receiver so I was wondering if there is a way to use dual receivers for the additional functions. The functions for the most part will just be on/off.
Thanks, Andy |
Deleted.
|
Originally Posted by oldtyme
(Post 12222407)
I have a 14SG radio and a couple of planes that I want more functions than an 8-channel receiver will handle. I don't want to buy a 14 channel receiver so I was wondering if there is a way to use dual receivers for the additional functions. The functions for the most part will just be on/off.
Thanks, Andy |
Originally Posted by rgburrill
(Post 12222595)
AMA 16066? Gotta be trolling.
|
Originally Posted by rgburrill
(Post 12222595)
AMA 16066? Gotta be trolling.
|
oldtyme
Check your RC Universe Private Messages. Should help with your question. Woodie |
The R6208SB receiver can be set so that it will accept channels 1-8 or channels 9-16. This allows you to get all the channels on two receivers. You could also use the S-bus to have all the channels using one receiver. Any "SB" receiver will do that for you.
|
Originally Posted by woodie
(Post 12222823)
oldtyme
Check your RC Universe Private Messages. Should help with your question. Woodie After reading the T14SG manual further, on page 73 in the upper right hand part of the page, there is instruction on how to program the transmitter to a dual receiver function. It does state that this can only be donein the FASSTest 14CH mode but at least that answers my question. I'm also going to play with Sbus as well. |
All times are GMT -8. The time now is 04:57 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.