Help trainer mode Futaba T12K
Hi all,
I have two futaba T12K and I'd like to use one trasmitter as instructor. So I've follow manual but there are some misunderstanding. In instructor trasmitter I have active trainer mode ans I set ch mode to 16CH. I set AIL ELE THR and RUD to MIX mode. To activate trainer mode I hae SH switch. If I actie my switch trainer mode pass to ON and OFF. In student trasmistter I've only set CH mode to 16CH. If I plug trainer wire and actiate trainer mode from instructor trasmitter it's not working properly for me, if I move THR stick from instructor trasmitter I don't see any changes in servo student transmitter, but if I move THR stick to student transmitter THR servo in instructor transmietter move this is not logic ?? And THR servo is reversed why ? |
Have you actually tried this with a servo connected?
The student TX really does nothing except send the signal to the teacher TX which transmits it to the RX. |
All times are GMT -8. The time now is 03:35 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.