RCU Forums - Super 8 Servo Programming

RCU Forums (https://www.rcuniverse.com/forum/)

- Futaba Radios Direct support forum (https://www.rcuniverse.com/forum/futaba-radios-direct-support-forum-125/)

- - Super 8 Servo Programming (https://www.rcuniverse.com/forum/futaba-radios-direct-support-forum-125/1710952-super-8-servo-programming.html)

coveredup

04-10-2004 10:18 PM

Super 8 Servo Programming

I was wondering if it is possible to "program" digital servos with this transmitter. Not being familiar with digital servos, which tx will do this? Must I buy a separate "programmer"?

Thanks,

Coveredup

Bax	04-13-2004 05:01 PM

RE: Super 8 Servo Programming

The Futaba 8U Super transmitter has no capability to program servos. All programming is done in the transmitter. If you have programmable servos, then you'll have to have the programming device for those servos. The 8U transmitter won't do it.

Futaba's digital servos are not programmable. The digital referse to the internal signal handling that gives them better holding power than non-digital servos.

(edit to add info)

All times are GMT -8. The time now is 11:33 PM.