Converting a 2pos switch to a 3pos switch
Dear Bax / Krysta,
I want to make sure I understand something based on a previous member's post. If I send my 12FG in for service and ask to replace the 2 position switch with a 3 position switch (i.e.; the top left rear one), will the software also be changed so all of the programming would recognize it as a three position switch? If so, how much would this cost? Best Regards... Roger |
RE: Converting a 2pos switch to a 3pos switch
Hi Roger,
Yes, if you send this in to have a switch changed in it's configuration, we have to do a software change here to make sure that the programming follows the switch. The charge for doing so would be $50.00. Sincerely, Krysta Product Development & Support Specialist Futaba Service Center USA [email protected] |
All times are GMT -8. The time now is 09:10 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.