Go Back  RCU Forums > Glow Engines, Gas Engines, Fuel & Mfg Support Forums > Gas Engines
Reload this Page >

Spring Starter and Zenoah G-45 Setup?

Notices
Gas Engines Questions or comments about gas engines can be posted here

Spring Starter and Zenoah G-45 Setup?

Old 04-18-2012, 04:04 PM
  #1  
Loopman
Thread Starter
My Feedback: (195)
 
Join Date: Feb 2002
Location: Duluth, GA
Posts: 788
Likes: 0
Received 0 Likes on 0 Posts
Default Spring Starter and Zenoah G-45 Setup?

Well, Here I go again! I've got a Zenoah G-45 and a Bennett spring starter for it. How do I set up the spring starter? Where do I position it and then where do I position the prop?

Happy Flying!

Loopman
Old 04-18-2012, 08:11 PM
  #2  
karolh
 
Join Date: May 2002
Location: Mandeville, JAMAICA
Posts: 6,808
Received 28 Likes on 27 Posts
Default RE: Spring Starter and Zenoah G-45 Setup?

Fitting the recoil spring starter is pretty straightforward. The body of the starter assembly bolts on to the rear taper of the crank, and the spring eye section is held in place with the supplied bolt on the rear of the crankcase, and can only work in one position. Just ensure that the locking nut on the end of the crank is tightened properly, otherwise the starter will slip when the spring is wound up by the prop when attempting to start the engine. I find that just setting the prop horizontal works well for me, and a half a turn of the prop/spring generates sufficient mag speed to get your engine going.

Karol

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.