Zanoah g26 problem
 

Zanoah G26 on H9 T-Craft. Bought new last Nov. Engine now has a knocking sound. Real distinct from idle to mid stick. Above mid-stick cant hear it. Any one ever had this problem? Plz advise.
NC State

RE: Zanoah g26 problem
 

Engines need a little slop(sounds better to call it "clearance") in the con rod to allow the piston to go past TDC without binding, but yours may have a little extra. Pulling the cylinder/head to take a look is easy enough.

RE: Zanoah g26 problem
 

ec121, thanks for your reply. When the engine was new, it ran real smooth. Now when it runs, the engine will shake every time you hear the knocking. Talked to Horizon, they said, send it back. I sure dont want to go thru all that mess.
NC State

RE: Zanoah g26 problem
 

Just do as Horizon suggests and save yourself a lot of headaches later on, as that's the main reason for having warranties.

Karol

RE: Zanoah g26 problem
 

Engines will "knock" if they are set too rich, try resetting both needles before you give up and send it back.
Larry

RE: Zanoah g26 problem
 

send it back!

RE: Zanoah g26 problem
 

Send that engine back while you can............

RE: Zanoah g26 problem
 

I see you are fairly new here. The three guys that told you to send it back are three very knowledgeable people on this site. I would head their sugesstion and sent it back before something catestrophic happens and costs you an airplane.

The Pamster
AMA 202345

RE: Zanoah g26 problem
 

thanks all for your reply. sending it back.
NC State

RE: Zanoah g26 problem
 

Try tightening the nut on the rotor at the rear....