WJ71 THROTTLE ARM PNP
 

I have had many people wanting an easier method of connecting a throttle linkage to the WJ71 Walbro carb so your problems have been resolved. Parts are top notch and machined right here in the USA by one of the best. <div></div><div>This arm will retain factory throttle/choke release but I recommend removing throttle stop/idle set.</div><div></div><div>Connection detail:</div><div></div><div>Pin from arm goes into small hole on carb stock arm.</div><div>Threaded nut goes into backside of stock carb arm and is attached with supplied screwed.</div><div>2 open threaded connections are for ball link attachment, you pick which one works best for you.</div><div></div><div>Price will be $12 plus shipping for the arm kit.</div><div></div><div>Thanks Guys, I hope this makes it alittle easier for you installing your JC120. If you need an easier choke setup I suggest using Spot on Choke Arms.</div><div></div><div>Install pics Below.</div><div></div><div>http://i244.photobucket.com/albums/g...-39-27_471.jpg</div><div>http://i244.photobucket.com/albums/g...-39-37_851.jpg</div><div>http://i244.photobucket.com/albums/g...-40-40_579.jpg</div><div>http://i244.photobucket.com/albums/g...-41-20_372.jpg

Thanks
www.vital-rc.com</div>

RE: WJ71 THROTTLE ARM PNP
 

Nice fix, I find the engine manufacturer at fault here. You purchase a purpose build Model Aircraft engine with a carb right off the chain saw, modifiactions are necessary right out of the box. It's nice some manufactures like DA and D&amp;Bhave added those at the factory, I'm sure there are others.

RE: WJ71 THROTTLE ARM PNP
 

I think his market will be for the folks that replace the junk Chinese carb with a genuine Walbro.

RE: WJ71 THROTTLE ARM PNP
 

Last time I checked the WJ71 was a genuine Walbro carb, used on DA and ZDZ engines for sure, 80 to 100 CC

RE: WJ71 THROTTLE ARM PNP
 

We agree but, for example. the DLE and DLA twins are equipped with knock-off clones of the Tilotson carb. I replaced the one on my DLE111 with a genuine Walbro WJ-71. I made my own throttle arm from G10 but had this product been available at the time I may have purchased one.

RE: WJ71 THROTTLE ARM PNP
 

WJ71 is a legit carb and works really well on 100cc class motors. I have great results with them on my jc120evos.<div>
</div><div>http://www.teamflyingcircus.com/foru...-13-40_945.jpg
</div>

RE: WJ71 THROTTLE ARM PNP
 

Where did the question of whether the WJ71 is a genuine Walbro carb come in to play?