Fuji 43 .... need a couple of parts
 

I have the Fuji 43 and I need the fiber part that goes between the prop and the crank.. it is like sand paper and is a disk shape... Also would like the mounting bolt that is drilled so that a spinner can be installed...

Would really like any suggestions on these two items as to what can I do to if the parts are not available... thanks...

Fuji is no longer in the model business.

http://www.truturn.com/af.htm

Make your own sandpaper washer

Thanks for the reply..... I was hoping that someone may still be handling the parts... Richard

TOWER still has just a few parts but not the ones you are looking for.

You will just have to be resourceful? Use sand paper for the prop bushing.

Figure out the thread size on your crankshaft and you can use one made for a different engine? I had a friend tap a regular bolt for me in a lathe for the spinner screw on my Zenoah G62,

Thanks again w8ye for the very helpful information... I believe I can solve my two problems.... Thanks...