Question on kill switch for magneto ignition
I would like to setup a servo operated microswitch for ignition cutoff for a Zenoah 26cc with MAGNETO ignition. My question is: What parameters (voltage, current, other) do I need to observe when selecting the switch ? |
|
Originally Posted by BarracudaHockey
(Post 12441213)
|
Thought that was what I posted.
Good luck in your search |
This is what I used to use on Zenoahs. Products found matching 'RC'. - RCATS Webstore - (Powered by CubeCart) |
Any microswitch rated for 110-250v / 10 amp or higher will work
|
Originally Posted by CK1
(Post 12441504)
Any microswitch rated for 110-250v / 10 amp or higher will work
|
Originally Posted by huggins
(Post 12441314)
This is what I used to use on Zenoahs. Products found matching 'RC'. - RCATS Webstore - (Powered by CubeCart) |
I have used microswitches like this as a magneto grounding switch (kill switch). This is just a generic photo, they are available with different operator arms on them also. The Zenoah toggle switch will also work with modification, I drilled a hile in the toggle operator and used a pushrod and servo to operate the toggle switch before.
https://cimg8.ibsrv.net/gimg/www.rcu...86b262c68d.jpg |
All times are GMT -8. The time now is 10:56 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.