Nelson 40 Help
#1
Thread Starter
My Feedback: (1)
Join Date: Jul 2005
Location: Spilimbergo, ITALY
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Nelson 40 Help
Good Morning.
I have an old version of Nelson 40.
I need the rear ball bearing, the dimensions are 19x30mm.
Anyone know where it is possible to find this ball bearing?
Thanks,
Max.
I have an old version of Nelson 40.
I need the rear ball bearing, the dimensions are 19x30mm.
Anyone know where it is possible to find this ball bearing?
Thanks,
Max.
#4
Member
Join Date: Dec 2005
Location: Newman,
CA
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
RE: Nelson 40 Help
If your crankshaft is 19mm in diameter I believe you assemble the balls directly on the crankshaft along with the outer race of the bearing. I think you need a 30X17X7mm bearing then pop out the retainer, assemble the balls on the crank along with outer race, then pop the retainer back in, then install the crank with bearing in the case. Not completely sure because the pictures of your motor are blurred, hope I've helped.