33% Landing Gear
#1
Junior Member
Thread Starter
My Feedback: (5)
Join Date: Oct 2008
Location: Taylorville,
IL
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
33% Landing Gear
I would like to find a good main gear for my H9 33% Edge.
I would appreciate all opinions on what gear to use and where to get them. Aluminum and CF
Thanks
I would appreciate all opinions on what gear to use and where to get them. Aluminum and CF
Thanks
#2
My Feedback: (29)
RE: 33% Landing Gear
Try this, I ordered a few sets and some spinners from this outfit and was quite pleased.
http://cgi.ebay.com/Carbon-fiber-lan...item3363364053
http://cgi.ebay.com/Carbon-fiber-lan...item3363364053
#5
Senior Member
Join Date: Jun 2007
Location: Egg Harbor City,
NJ
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
RE: 33% Landing Gear
http://www.graphtechrcshop.com/categ...2?categoryId=9 All on Sale @ GT,good luck
#6
My Feedback: (41)
RE: 33% Landing Gear
ORIGINAL: 183AMMO
I would like to find a good main gear for my H9 33% Edge.
I would appreciate all opinions on what gear to use and where to get them. Aluminum and CF
Thanks
I would like to find a good main gear for my H9 33% Edge.
I would appreciate all opinions on what gear to use and where to get them. Aluminum and CF
Thanks
http://www.horizonhobby.com/Products...ProdID=HAN1160
Horizon re-released this model awhile back so new replacement parts are available if you want.
If you prefer aluminum, I'd go with TNT or they also have CF.
#7
Senior Member
My Feedback: (1)
Join Date: Nov 2009
Location: Anytown
Posts: 1,287
Likes: 0
Received 0 Likes
on
0 Posts
RE: 33% Landing Gear
I replaced my original set (delaminated on sixth flight) back in '04 with a set from TNT. Not as scale but they gave better ground clearance and I never had a problem with the gear again. They did not survive a full throttle dive in to a tree, however.
#8
My Feedback: (41)
RE: 33% Landing Gear
I know there were reported problems with the factory gear delaminating, but I've had one of these models for about 4 years now with no issues. I have a friend with one and he has had the delamination but he's also done a number of, shall we say less than good landings for various reasons including deadsticks so I don't think any CF gear would have survived that particular issue.