Fly Model 50cc MX 2
06-23-2014, 01:28 PM
#1
Junior Member
Thread Starter
My Feedback: (2)
Join Date: Sep 2009
Location: ft.worth,
TX
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Fly Model 50cc MX 2
Thought I would share some photos and comments for those who are wondering this is my second fly model I had a 30cc it was so nice for the price I sold it and bought this 50cc
This is not a build log
Super fast shipping double boxed no damage, Covering very nice only few wrinkles no biggie
i have not flown this yet only rapping up building her hopefully get to fly her this weekend
i have owned a lot of arf,s this is right there with the high dollar name brands at half the price pretty much
i got her under $380 shipped carbon fiber spinner and landing gear and wing spars
Couple small things turnbuckles where to short no biggie
and im im runnng a DLE 55 RA the rear exhaust to get the spinner matched with the cowl the muffler hits the bottom of the box so I sanded a 45 degree angle at the bottom of the box used SWB stand off kit, pinned the box and fuel proofed with epoxy VERY QUICK,EASY DEPENDABLE SETUP
So all I changed is I used Robart Hinges, Smaller gas Tank, I changed some screws to socket heads instead of screw heads
This is not a build log
Super fast shipping double boxed no damage, Covering very nice only few wrinkles no biggie
i have not flown this yet only rapping up building her hopefully get to fly her this weekend
i have owned a lot of arf,s this is right there with the high dollar name brands at half the price pretty much
i got her under $380 shipped carbon fiber spinner and landing gear and wing spars
Couple small things turnbuckles where to short no biggie
and im im runnng a DLE 55 RA the rear exhaust to get the spinner matched with the cowl the muffler hits the bottom of the box so I sanded a 45 degree angle at the bottom of the box used SWB stand off kit, pinned the box and fuel proofed with epoxy VERY QUICK,EASY DEPENDABLE SETUP
So all I changed is I used Robart Hinges, Smaller gas Tank, I changed some screws to socket heads instead of screw heads
Last edited by DannyLooper; 06-23-2014 at 01:40 PM.
06-27-2014, 06:24 PM
#2
Junior Member
Thread Starter
My Feedback: (2)
Join Date: Sep 2009
Location: ft.worth,
TX
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Ok I got to get one flight in today the maiden flight
Very pleased I flew in 20 to 30mph wind pretty windy
She was flying awesome tracked perfect, one click of aileron trim, CG was right on although she balanced nose heavy on the recommended specs she was only a tad nose heavy probably slide the batteries back 1/2 inch back or even take one life out and just fly with one life instead of 2
All I can say right now is NICE
Plan to burn about 5 tanks Sunday hopefully
Very pleased I flew in 20 to 30mph wind pretty windy
She was flying awesome tracked perfect, one click of aileron trim, CG was right on although she balanced nose heavy on the recommended specs she was only a tad nose heavy probably slide the batteries back 1/2 inch back or even take one life out and just fly with one life instead of 2
All I can say right now is NICE
Plan to burn about 5 tanks Sunday hopefully
