RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Glow to Electric Conversions (https://www.rcuniverse.com/forum/glow-electric-conversions-132/)
-   -   .40 Size Electric (https://www.rcuniverse.com/forum/glow-electric-conversions-132/11680412-40-size-electric.html)

Bikerboy53 07-09-2020 06:21 AM

.40 Size Electric
 
Hey all,

I have a .40 size electric motor that I reversed the shaft on by removing the "e-clip" and then pressing the shaft out to the other end so that I could use a collet for my spinner, the shaft is secured to the motor can by means of a set screw on the prop-end, the other end that goes against the firewall doesn't have the e-clip any longer because there is no groove for it, it just protrudes past the bearing a tiny bit. As of right now, the magnets are basically holding the can in place, but if I pull hard enough I can remove the entire can, prop, and spinner from the winding's....lol, are the magnets going to be strong enough to keep it secure while its spinning?, or will I need to secure the other end somehow with an e-clip?

Thanks all

Biker

0305030angus 08-20-2020 12:46 AM

Same problem, bro


All times are GMT -8. The time now is 03:41 PM.


Copyright © 2022 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.