Saito 82a vs 82b
Are there any significant differences between the Saito 82a and the 82b?
|
RE: Saito 82a vs 82b
They run the same for the moving parts, cylinder, exhaust, and carb are the same.
The only thing different is the crankcase, back plate, and the stationary cam pivot shaft. |
RE: Saito 82a vs 82b
Hi w8ye just put new bearings in my Saito 72 , running a 13/6 apc and 20 % FUEL getting about 10800 -11000 rpms idles at just under 3000 is this what I should expect , runs very strong , thanks BobA Saito club member 705
|
RE: Saito 82a vs 82b
Sounds just right to me. Get it up in the air and enjoy
|
RE: Saito 82a vs 82b
ORIGINAL: w8ye They run the same for the moving parts, cylinder, exhaust, and carb are the same. The only thing different is the crankcase, back plate, and the stationary cam pivot shaft. |
RE: Saito 82a vs 82b
The 82B has the cam setting down inside the crankcase with a almost flat cover acrossd the top
The 82A has the cam within a cover that sits on top of the crancase. It is the same cam in the same place - it is just a matter of how it looks to the eye. The "A" version crankcase will break at the junction between the cylinder and cam box in a bad crash that catches on the cylinder, I don't see that it makes a lot of difference for repairing crashed Saitos, one that hit that bad is pretty well done for anyway. This all started with a redesign of the Saito 82 into becoming the FG-14 gasoline engine. The then went back and changed the 82 and 72 glow engines to have a crankcase like the FG-14. The crankcase is common between the 72 and 82 anyway except for the number on the side. |
RE: Saito 82a vs 82b
My Saito 100 has an almost flat cam cover with the major portion of the cam housing cast into the crankcase.
|
RE: Saito 82a vs 82b
And that is the way the 82B is
|
RE: Saito 82a vs 82b
Thank you, sir.
|
RE: Saito 82a vs 82b
I have the 82a old style. Will the smae cam cover gaskets fit both the A and B models? I didn't see any parts for the old A model on Horizon.
|
RE: Saito 82a vs 82b
They are different.
The cam cover gasket for the 91 will work on the 82A or you can cut your own. It is important that the gasket be about .008" thick |
RE: Saito 82a vs 82b
Thanks W8ye
|
All times are GMT -8. The time now is 08:40 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.