RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Glow Engines (https://www.rcuniverse.com/forum/glow-engines-114/)
-   -   YS63 Regulator Question (https://www.rcuniverse.com/forum/glow-engines-114/190209-ys63-regulator-question.html)

CHM 07-10-2002 03:21 AM
YS63 Regulator Question
 
The regulator body on my 63 has a raised tab. Should it be positioned to the front or rear?

Thanks

visioneer_one 07-10-2002 03:39 AM
YS63 Regulator Question
 
Rear.

What was floating arount in there causing your problem?

CHM 07-10-2002 03:46 AM
YS63 Regulator Question
 
Thanks!

I didn't see a thing!

Has YS chanced the plunger? Mine looks like silicone on the spring side, and a brass plate on the motor side. I couldn't figure how to take it apart.

I'll run it again tomorrow.

Chuck

w8ye 07-10-2002 10:19 AM
YS63 Regulator Question
 
raised tab goes to front on mine

Jim

visioneer_one 07-10-2002 12:50 PM
YS63 Regulator Question
 
Originally posted by antispad

I didn't see a thing!

Has YS chanced the plunger? Mine looks like silicone on the spring side, and a brass plate on the motor side. I couldn't figure how to take it apart.
It doesn't take a big chunk in there to upset the regulator. A small sliver of plastic swarf from your fuel tank is all it takes.

The silicone bit is press-fitted onto the brass plunger (and is a PITA to find if you drop it, so be careful!) As long as you've flushed the regulator body out with alcohol or fuel you should be OK. Make sure you don't snag the diaphragm when you reattach the regulator assembly.


All times are GMT -8. The time now is 04:00 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.