Moki/ ST radial mount
I'm installing a Supertigre and was considering using the radial mount. That mount makes it kind of awkward to run a straight shot from the throttle servo to the carb arm. What do most people do with this kind of mount? Do you drill it out, go around it.... what.....?
Thanks[8D] Jim |
RE: Moki/ ST radial mount
Drill out out or better still, if you have a friend with some milling equipment, mill the mount out in a similar vain to a lightened spinner backplate.
I've seen some real beauties... one of then even done manually using a series of holes and a file. Cracking job. |
RE: Moki/ ST radial mount
Thanks for the reply Bla Bla. I'm hoping someone will post a photo or two if they've done it!
Jim |
RE: Moki/ ST radial mount
Well BlaBla I did it and it turned out pretty well. The aluminum is soft enough to drill easily and I rounded off the sharp corners with my dremel. Thanks
Jim |
RE: Moki/ ST radial mount
Send us a picture Jim.
|
RE: Moki/ ST radial mount
OK, give me a day or so to round up my camera, etc
Jim |
RE: Moki/ ST radial mount
Hi BlaBla:
Here you go... not the best photos lbut you can see where I drilled mount for fuel line and throttle rod. This is gonna work just fine. Jim[[img][/img] |
All times are GMT -8. The time now is 08:16 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.