RCU Forums - need help with esc, receiver

RCU Forums (https://www.rcuniverse.com/forum/)

- Helimax (https://www.rcuniverse.com/forum/helimax-462/)

- - need help with esc, receiver (https://www.rcuniverse.com/forum/helimax-462/6899122-need-help-esc-receiver.html)

Flying Foot Doc

01-13-2008 08:41 AM

need help with esc, receiver

Hi, I have the new ESC and receiver for the ones I burned up. On the ESC, there are two leads that end in micro deans, a long one and a short one. Which one goes to the tail motor and which one geos to the battery? On the receiver when I tried hooking up the esc 3 wire lead to the 3rd channel from the top and the orange lead to the inside pin on the 4th channel, I get servo control, but no motor control for the main or tail. I have the short Deans lead connected to the tailmotor. Thanks, Doc

Shadow99

01-13-2008 11:43 AM

RE: need help with esc, receiver

1 Attachment(s)

Doc,

You may have the leads backwards, on the 3in1 of the AXE CP the INPUT is on one side (Micro Deans to Battery), the other side has 2 18 ga wires for the main motor, the other pigtail with the Micro Deans connector is for the tail motor.

Flying Foot Doc

01-13-2008 01:07 PM

RE: need help with esc, receiver

Thanks, I'll check. Something isn't right. Doc

All times are GMT -8. The time now is 09:04 AM.