New Aurora 9 User - Minimum Receiver Voltage
12-26-2010, 08:14 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2007
Location: TownsvilleQueensland, AUSTRALIA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
New Aurora 9 User - Minimum Receiver Voltage
I have just purchased a new Hitec Aurora 9 after using JR radio gear since 1979. I have around 30 aircraft set up with JR/Spektrum gear and guided by the wonderful JR 11x.
I was taken to the Hitec mainly due to the ability to use the telemetry gear, in particular the onboard voltage monitor and GPS functions.
My question is (I apologise in advance if this is already covered in a thread somewhere) what is the minimum recommended operating voltage for the Optima receivers ( 6, 7 and 9 - I assume they will all be the same parameters).
I was taken to the Hitec mainly due to the ability to use the telemetry gear, in particular the onboard voltage monitor and GPS functions.
My question is (I apologise in advance if this is already covered in a thread somewhere) what is the minimum recommended operating voltage for the Optima receivers ( 6, 7 and 9 - I assume they will all be the same parameters).
