Jittery Servos with RCD 3200
02-02-2004, 02:06 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2001
Location: West Bridgewater,
MA
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
Jittery Servos with RCD 3200
Hi Mike:
I have a Hitec RCD 3200 receiver (Futaba) that I am using with 2 JR 4131 servos, and 2 JR 4031 servos. If I swamp the receiver (get the tranny antenna close to the receiver antenna) the 2 4031's get all jittery, but not the 4131's. I tried it with a different receiver (an old Challenger 720) and it didn't do it, so I am assuming it is some kind of a compatability issue. Do you have any thoughts? Do you think it will be a problem?
Thanks
Alan Angus
I have a Hitec RCD 3200 receiver (Futaba) that I am using with 2 JR 4131 servos, and 2 JR 4031 servos. If I swamp the receiver (get the tranny antenna close to the receiver antenna) the 2 4031's get all jittery, but not the 4131's. I tried it with a different receiver (an old Challenger 720) and it didn't do it, so I am assuming it is some kind of a compatability issue. Do you have any thoughts? Do you think it will be a problem?
Thanks
Alan Angus
