Servo prog & 5125
03-10-2004, 09:27 PM
#1
Thread Starter
My Feedback: (4)
Join Date: Jan 2002
Location: Deland,
FL
Posts: 1,928
Likes: 0
Received 0 Likes
on
0 Posts
Servo prog & 5125
I just got the Programmer - late Christmas gift if you can believe it. That's how it goes betwen flying buddies.
Anyway, my assumption was that I would be able to use the servo speed function to slow the servo to a 1-2 sec time for full travel. This would allow flaps to be switch deployed - but not have the immediate trim disruption caused by sudden flaps.
So, the first servo i tried this with was a 5125. I changed the speed settings all over the range, but the servo response looked pretty much the same when cycling it manually with the knob.
Am I missing something?
Anyway, my assumption was that I would be able to use the servo speed function to slow the servo to a 1-2 sec time for full travel. This would allow flaps to be switch deployed - but not have the immediate trim disruption caused by sudden flaps.
So, the first servo i tried this with was a 5125. I changed the speed settings all over the range, but the servo response looked pretty much the same when cycling it manually with the knob.
Am I missing something?
