hs 805 bb
04-05-2004, 04:50 AM
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: North Italy, , ITALY
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
hs 805 bb
Hallo Mike,
I'll use two HS-805BB on my 1/3 scale glider, one for the
tow release and the other on the rectractable landing gear...these servos
won't work at the same time: any suggestions to connect the same 6V battery
pack only for these servos?? Thanks
04-08-2004, 02:05 AM
#3
Senior Member
Thread Starter
Join Date: Oct 2002
Location: North Italy, , ITALY
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
RE: hs 805 bb
This servo has a high current drain, and it is recommended to use a separate high capacity 6V battery....is it correct the configuration ?? See figure:Thanks Alfo
04-10-2004, 11:16 AM
#4
My Feedback: (31)
RE: hs 805 bb
Alfo
This will work. There will be a problem with the five cell pack on the servo wyes. If you want to run the five cell pack, I would remove the power pin from the wyes that allow 6.0V to travel to the RX, which has its own four cell 4.8V battery.. Or simply use two five cell 6.0V batteries.
This will work. There will be a problem with the five cell pack on the servo wyes. If you want to run the five cell pack, I would remove the power pin from the wyes that allow 6.0V to travel to the RX, which has its own four cell 4.8V battery.. Or simply use two five cell 6.0V batteries.
