EVO 12 - Servo Jitters
06-12-2005, 11:03 PM
#1
Senior Member
Thread Starter
My Feedback: (20)
Join Date: Dec 2002
Location: Franklin,
TN
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
EVO 12 - Servo Jitters
I have an EVO 12 transmitter that I am attempting to set up on a pattern plane with retracts. The receiver is Futaba, and the transmitter is in Mode 2. I the set ACRO template, and then added the retracts to switch J. I also set the throttle cut switch on the Kta switch on the top of the control stick, and set the aileron D/R on the Ksw switch.
Everything seems to work fine with the retracts down. When I put the retracts up, I get a problem. The servos jitter violently when I do any of the following:
rudder stick left
aileron stick left
elevator stick up
throttle down
Any ideas about what is wrong? Any help would be greatly appreciated. I could not fly the plane with this transmitter, if this problem is not corrected.
Lem
Everything seems to work fine with the retracts down. When I put the retracts up, I get a problem. The servos jitter violently when I do any of the following:
rudder stick left
aileron stick left
elevator stick up
throttle down
Any ideas about what is wrong? Any help would be greatly appreciated. I could not fly the plane with this transmitter, if this problem is not corrected.
Lem
06-13-2005, 07:50 PM
#2
Senior Member
Thread Starter
My Feedback: (20)
Join Date: Dec 2002
Location: Franklin,
TN
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
RE: EVO 12 - Servo Jitters
More info: I was wrong about the receiver, it is a Hitec RCD 3500 8 Ch Supreme. I switched the receiver to a Multiplex 9 ch IPD receiver, and the problem goes away.
