Hitec 5955 Servos-Y Harness
01-06-2008, 01:25 PM
#1
Junior Member
Thread Starter
My Feedback: (2)
Join Date: Feb 2003
Location: Meriden,
CT
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Hitec 5955 Servos-Y Harness
Hi,
I have used JR servos forever but have seen the 3-D boys using more and more Hitec so I thought I would give them a try. I bought four (5955), two for the ailerons and two for the flaps. They are working off a 7 channel JR 2.4MHz receiver with a Y-Harness in the ailerons and flaps. They work great seperately but when connected to the Y-harnes just one works. The other one sometimes moves a little and stays in that position or moves with a delay. The JR servos connected to the same Y-harness worh fine. What am I doing wrong?
John
I have used JR servos forever but have seen the 3-D boys using more and more Hitec so I thought I would give them a try. I bought four (5955), two for the ailerons and two for the flaps. They are working off a 7 channel JR 2.4MHz receiver with a Y-Harness in the ailerons and flaps. They work great seperately but when connected to the Y-harnes just one works. The other one sometimes moves a little and stays in that position or moves with a delay. The JR servos connected to the same Y-harness worh fine. What am I doing wrong?
John
01-06-2008, 03:19 PM
#2
Junior Member
Thread Starter
My Feedback: (2)
Join Date: Feb 2003
Location: Meriden,
CT
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hitec 5955 Servos-Y Harness
Hi,
I found the problem. A weak receiver battery. When replaced with a good 5 cell battery they are working fine.
John
I found the problem. A weak receiver battery. When replaced with a good 5 cell battery they are working fine.
John
