A9 flap- elevator programming
I am trying to set up down elevator with the application of flap.
I am using the LS slider for flap control and using the 'FLAP CON' selection to mix elevator with flap. Tha problem I am encountering is that the elevator only moves when the LS slider is in the full up position. I would like the full up position to represent flap up and as I move the slider down that would lower the flaps. I cannot seem to get elevator movement when the LS slider controll is fully down. So what I get after adjustment is flaps up, elevator down, and as I move the slider down to lower the flaps, the elevator moves up to neutral. Is there a way to have the elevator move as I move the LS slider down? Thanks, Dan |
RE: A9 flap- elevator programming
What version firmware do you have in your radio? With v1.07(1) (latest version) this mix works properly. Set LS slider up and adjust flap horn on servo spline for your setup. If servo moves the wrong way use the servo reverse screen to reverse that channel. Adjust travel for flaps and elevator compensation in your flap control menu.
|
RE: A9 flap- elevator programming
Thanks for your reply.
I did just load in V 1.07 so I will try it again today. Dan |
All times are GMT -8. The time now is 02:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.