Surface freq's 61-90 in a Flash 4?
I do kite aerial photography KAPing and need a four channel radio to control the kite lifting camera rig. Since its not an aircraft, I think it would be safer to use a surface frequency. Just so I don't shoot down a model aircraft. Can I use surface frequency crystals in something like a Flash 4 transmitter and a Feather receiver? Will it work?
Thanks, Tom |
Surface freq's 61-90 in a Flash 4?
The only suface use radios with more than 3 channels are the Laser 4 & 6. You cannot just plug in 75mhz crystals into a 72mhz system.
However, you are really using it for air use so you should be OK on 72mhz if you want to use the Flash. Mike. |
Surface freq's 61-90 in a Flash 4?
Ok, thanks Mike.
I'm going to use my Flash 5 and just be darn careful if I'm anywhere near a flying field. Any chance you have any information on how far the range could be with a Flash 5? I know that if you can see the model, you should be able to control the model ( or in this case, shoot it down). I'm just thinking, what is the closest proximity I could get to an airfield with a Flash 5 turned on and not shoot anyone down on that frequency. |
Surface freq's 61-90 in a Flash 4?
3-5 miles is a safe distance.
Mike. |
Surface freq's 61-90 in a Flash 4?
ok, thanks Mike. I'll be damn careful.
|
All times are GMT -8. The time now is 07:25 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.