| Astrolv |
02-11-2016 06:40 PM |
Slipper clutch rebuild G3.0
I'm new to the nitro Rc world. On my first car actually. A friend sold me an hpi G3.0 I don't know if it's a bullet or what but we were supposed to build one from scratch but this used car complete seemed easier. Now I'm in the process of rebuilding the slipper clutch. I don't know what rebuild kit fits or if the whole bell/ flywheel should be replaced or what. Kinda goin at it blind. Any and all advice, tricks, short cuts, not to do's etc would be greatly appreciated
|
