Go Back  RCU Forums > RC Airplanes > RC Jets > Turbine Clinic > JetCat Turbine Direct Support
Reload this Page >

Jetcat Pro ECU Telemetry with Futaba 18MZ

Notices
JetCat Turbine Direct Support Ask your JetCat questions here for the experts that know them. MrMatt and Bob Wilcox will field your inquiries.

Jetcat Pro ECU Telemetry with Futaba 18MZ

Old 05-30-2022, 07:18 AM
  #1  
Adi_idA
Junior Member
Thread Starter
 
Join Date: May 2022
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default Jetcat Pro ECU Telemetry with Futaba 18MZ

Hi,

I am using a P250 Pro with the Jetcat pro ECU and would like to get telemetry data thru SBUS2 on my Futaba 18MZ radio.

When selecting telemetry sensor options, I can see Jetcat V10 in the sensor list but it all values show 0. Please help

Thanks!

Old 05-30-2022, 11:15 AM
  #2  
Dave Wilshere
 
Join Date: Jun 2002
Location: Watford, UNITED KINGDOM
Posts: 12,756
Received 601 Likes on 434 Posts
Default

It’s not a V.10 ECU.
Never used telemetry, but it’s the Pro software you need.
Old 05-30-2022, 01:44 PM
  #3  
George
My Feedback: (57)
 
Join Date: Dec 2001
Location: Va Beach, VA
Posts: 3,069
Likes: 0
Received 11 Likes on 10 Posts
Default

I am assuming you are referring to the PRO interface as there is no "Jetcat pro ECU" because the ECU is integrated into the front board.

The JetCat Telemetry Module is not required. In order to get telemetry from the 250 to 18MZ, connect the lead from the interface Telemetry connection to receiver SBUS2 port, then set the TelemAdap parameter to :Extern, A=1, and Telemetry parameter to :Futaba SBUS-2 in the Limits menu. You should see the same version number for both (i.e. 8.70, etc.) in the upper right corner of the GSU if done correctly. When the sensor is registered to the 18MZ, it will still show "V10" for for all the sensor slots (i.e. RPM, Pump voltage, Temp., etc.) but works all the same.
The following users liked this post:
BIGBARPER (10-07-2022)

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.