powering a few led strips off select scan 700 channel
07-11-2012, 10:23 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2005
Location: Olfen,
TX
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
powering a few led strips off select scan 700 channel
I don't want to burn out my channel! I have a receiver controlled switch, so the power for a few gorilla Bobs led strips will come directly through my receivers rudder channel into the switch
My v max for the switch isn't my concern, its the max v through the receiver through the switch
I don't remember the specs on a few led strips...can you make a good guess if 2 or 3 small strips running through receiver channel will fry receiver?
My v max for the switch isn't my concern, its the max v through the receiver through the switch
I don't remember the specs on a few led strips...can you make a good guess if 2 or 3 small strips running through receiver channel will fry receiver?
