JR 9303 Tx
#1
Junior Member
Thread Starter
Join Date: Feb 2009
Location: RokebyTasmania, AUSTRALIA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
JR 9303 Tx
Memory problem with TX, I can select the required model memory ok but after flying when I turn the Tx off then back on to fly again, the Tx reverts to the last model memory programmed not the one I used for the last flight.
Can any help with this problem
Can any help with this problem
#3
Senior Member
Join Date: Jun 2010
Location: Sydney, AUSTRALIA
Posts: 4,786
Likes: 0
Received 0 Likes
on
0 Posts
I bought a DSX9 (JR9503) and it had a memory problem that it would not save anything after power off.
I ended up returning it and buying another.
http://www.youtube.com/watch?v=NvIQNVTu5Xk
#5
Senior Member
Join Date: Jun 2010
Location: Sydney, AUSTRALIA
Posts: 4,786
Likes: 0
Received 0 Likes
on
0 Posts
It may be the same problem I had. In Model 1, set the trims away from neutral, then turn off the radio.
Turn it on again and see if it remembers the trim positions or it may reset them to zero as mine did.
Give Model Flight a call in Adelaide, www.modelflight.com.au
They have always given me excellent service.
Turn it on again and see if it remembers the trim positions or it may reset them to zero as mine did.
Give Model Flight a call in Adelaide, www.modelflight.com.au
They have always given me excellent service.