Setting 4 Flap Servos with a DX18 and a 20310T Receiver
#1
Junior Member
Thread Starter
Setting 4 Flap Servos with a DX18 and a 20310T Receiver
Hello Guys, never used/set-up a 20 channel receiver before. I know the answer to my problem is starring me right in my face BUT I just don't see it yet. HELP I am setting up a jet. It has two split flaps/servos per wing. In my setup so far, I have one flap servo on channel 5 (left) and one servo on channel 7 (right). However, I am use to using "AUX" channels to plug the other two servos into to combine with the primary servo plugged into channel 5 and 7.
My problem is: The 20 channel receiver has no labeled "AUX" channels. Please explain how I am to
1. Connect the second of the two servos of the Left Wing into what channel that will align it with Ch 5 and
2. Then connect the second of the two servos of the Right wing into what channel that will align it with Ch 7
I'd like to thank all of you for your advice and help.
Chic
My problem is: The 20 channel receiver has no labeled "AUX" channels. Please explain how I am to
1. Connect the second of the two servos of the Left Wing into what channel that will align it with Ch 5 and
2. Then connect the second of the two servos of the Right wing into what channel that will align it with Ch 7
I'd like to thank all of you for your advice and help.
Chic
#4
Look at the Monitor screen.
The channels start at 1 for Throttle. Then 2 = right aileron, etc. Just go from there.
If you look at the Channel Assign screens, it will show both name and number if you get lost.
Andy
The channels start at 1 for Throttle. Then 2 = right aileron, etc. Just go from there.
If you look at the Channel Assign screens, it will show both name and number if you get lost.
Andy