*Dual Elevator Setup On 7202*
When setting up the 7202 radio for dual elevator servos I am using mix 6 and a little unclear as to how it should be set. This is what I have. If it's not correct, what should I have?
[PROG.MIX6] ELEV AUX2 ON RATE: +100% 0% SW:ON OFFSET: +100 |
RE: *Dual Elevator Setup On 7202*
Clear the offset back to 0, and set both of the rates to 100% (move the elevator stick to go between the values). Also go to the input select function and inhibit aux 2.
|
RE: *Dual Elevator Setup On 7202*
dsnyder,
Thanks for the info. |
All times are GMT -8. The time now is 10:06 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.