RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   JR Radio & Spektrum Radios (https://www.rcuniverse.com/forum/jr-radio-spektrum-radios-116/)
-   -   JR PCM9X program (https://www.rcuniverse.com/forum/jr-radio-spektrum-radios-116/5917860-jr-pcm9x-program.html)

flybye33 05-29-2007 05:23 PM

JR PCM9X program
 
Hi, I have flap sys enabled on new jet. 2 elevator servos, one slaved on Aux3.

Flap switch enables 5% down on elevator with flaps selected. Elevator servo is OK but the servo on aux three has no response..... All else is OK, just the down mix with flaps.

I had a similar setup with the P47 that worked OK but can't remember how I achieved it!

Any one like to help smarten up an old fella please?

Wlouigene 05-29-2007 10:00 PM

RE: JR PCM9X program
 
Elevators
Plug one side of the elevator into the ELEV channel and the other side into the AUX. 3 channel. Go into the System menu and choose Wing TYPE. Jog over to the Mate line under ELEV and push the roller button. A box will appear with 4 choices: GEAR, AUX2, FLAP & AUX3, choose AUX3. You have just mated the AUX3 channel with the Elevator channel; the radio will now refer to these channels as REL (right elev.) and LEL

flybye33 05-29-2007 10:45 PM

RE: JR PCM9X program
 
Thank you.

The manual I have is the old original and I couldn't figure out what it was telling me, your explanation has made it easy.





All times are GMT -8. The time now is 06:11 PM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.