RPM Barnstormer 25
#1
Senior Member
Thread Starter
My Feedback: (28)
Join Date: Dec 2001
Location: Near KC,
MO
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts

Trying to build this but confused on where the aileron servo goes, does it fit inside the fuse. Seen pics where they use two servos one in each wing, is this the way to go? Does it go in the middle on top of the wing, and if so how does the aileron horns connect? How about on the bottom of the wing? Thanks. reply here or to [email protected]
#2

Join Date: Mar 2013
Location: Winnipeg,
MB, CANADA
Posts: 751
Likes: 0
Received 0 Likes
on
0 Posts

Hi flyhi, I am not familiar with the Barnstormer 25 but as far as servo installation there are several ways to do an aileron servo or servos installation. If a single servo is used it is mounted in the middle of the wing and either aileron torque rods are used(just google "rc aileron torque rods") or bell cranks may be used. the servo is mounted so it will be inside the fuselage when the wing is mounted(usually). Another way to do it is to use one servo for each aileron, I am assuming this is a 25 size model though and unless you are using micro servos this is probably not needed.
Calvi
Calvi