H.O.B.
08-17-2002 | 01:04 PM
#1
Thread Starter
Senior Member
My Feedback: (1)
H.O.B.
Just send a note to Don at House of Balsa and he ought to clarify any of your concerns. Direct it to: [email protected]
Wm.
Wm.
06-01-2003 | 01:02 PM
#2
Senior Member
Joined: Dec 2001
Posts: 1,309
Likes: 0
Received 0 Likes
on
0 Posts
From: Rowlett,
TX
H.O.B.
I emailed them about this and you balance it with an empty tank.
I guess they have no interest in updating the instructions.
Balance it exactly where the show on the plans and it will fly great.
What engine are you using?
I put a TT-36Pro in mine, I think it is a wonderful combination. But I do like to fly straight up.
Good luck,
Charlie
I guess they have no interest in updating the instructions.
Balance it exactly where the show on the plans and it will fly great.
What engine are you using?
I put a TT-36Pro in mine, I think it is a wonderful combination. But I do like to fly straight up.
Good luck,
Charlie
06-02-2003 | 02:39 AM
#3
My Feedback: (12)
Joined: Jun 2002
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
From: klamath,
CA
H.O.B.
Charlie,
This plane has been flying for some time now and I did receive an answer from HOB about the proper balance. I put an inverted Magnum .30 four stroke in mine and it flies somewhat scale which is ok with me. Thanks for the imput. Dan O.
This plane has been flying for some time now and I did receive an answer from HOB about the proper balance. I put an inverted Magnum .30 four stroke in mine and it flies somewhat scale which is ok with me. Thanks for the imput. Dan O.
06-02-2003 | 11:12 PM
#4
Junior Member
Joined: Apr 2003
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
From: Madison, Ohio
H.O.B.
I am also building a house of balsa pt-19, It has a saito 30 4 stroke in it, I`ll be covering soon but I went looking for a prop nut for it and found out that they don`t make one small enough for the saito 30 size, they have them for the saito forty though, I was told to have one custom made for it. Do you have any ideas?
