Have plans, need kit cut.
Hi all. I have a few plans and I would like to have a company cut it for me into a kit. I seem to remember a company or 2 that used to do it. Any suggestions? thanks in advance.
|
Depending on the complexity I would recommend two cutters.
I have had good luck with Bob at Laser Design Services on more complex xesigns. For less complex I use Rob at The Balsa Workbench | Helpful hints for building balsa RC airplanes, by Rob Reynolds Rob is very reasonably priced too. Check them both out. |
Thanks!
|
All times are GMT -8. The time now is 02:04 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.