possible problem!??
 

hey guys,
i am building an astro hog and just found a problem. i was just doing the finishing sanding on the wing and somehow noticed the halves weren't the same length! so i got the numbers out and found that one side is 1/16 shorter then the other whitch is 1/16 longer then the short side! haha i can count[8D]. so is this gonna be a problem or is it just gonna be that thing that is always going to bother me??
thanks

adam

RE: possible problem!??
 

Who's wing half is not 1/16 shorter than the other??? :D:D:D

You will never know...

Matt

RE: possible problem!??
 

sand the 1/16th off the long one, but don't mix them up and sand it off the short one.

RE: possible problem!??
 

Measured twice, marked twice, cut it twice and it's still too short:D

RE: possible problem!??
 

ok i guess ill just have to fix it then
thanks guys

RE: possible problem!??
 

You could mount the wing 1/32" off the fuselage center :)

Don't spend any more time worrying about it - it's a non problem...

RE: possible problem!??
 

rcdude37

There is no way you'll detect the difference of 1/16" during flight. Shoot, you won't even notice that when it's on the ground. Just don't tell anyone and fly it.